Service Stabilitrak Chevy Cruze Issue and Its Repairmen Cost

1 min read

Service Stabilitrak Chevy Cruze Issue and Its Repairmen Cost

Service Stabilitrak Chevy Cruze is one of the most common found problem in this particular car model and other newer models from GM. StabiliTrak is a trademarked system from GM that provides stability for the vehicle. It works by giving warning in case your car cannot be supported due to the detected loss of lateral traction.

The warning indicates several things: there is a malfunction within the system, the system is shut down, or the system notice a poor signal. If the light of traction control in your Cruze is turned on as well, the problem most likely lays on the system. If the indicator light is turned on during driving and it persists, there’s a good chance you need to bring the car to service center. Now, note that when this warning light is switched on, the system is shut down and it can’t restrain wheel spins, so you need to control your driving.

What causes the Service Stabilitrak Chevy Cruze light to turn on, though? It occurs when the sensor of wheel speed detects that there’s a wheel that spins in faster rate than its counterparts, causing the car to lose traction or slip away. During this condition, the system is not able to help you control the traction. Without the traction control, your car is prone to slid or spin out on the road.

Now, if you see no crucial problem, you may turn off the service Stabilitrak and traction control Chevy Cruze. Simply press the button of StabiliTrak for a few seconds. Then rotate your steering wheel in clockwise cycle. If by performing this act makes the warning signal stops, then your car won’t require any service. However, if the signal is still proceeding, try to turn off your car, wait for several minutes, and turn the vehicle on in order to put reset of its system.

In case it turns out that traction control system of your vehicle needs to be fixed, you need to know about its cost. A replacement of traction control switch ranges $80 up to $95. The labor service may cost you anywhere $40 up to $50. Meanwhile, the part is sold at $40 to $45. The average cost of wheel sensors ranges between $100 up to $200, while you may expect the modules to be sold at $200 to $600. Keep in mind that these Service Stabilitrak Chevy Cruze service costs are merely estimation, and it might varies depending on your car’s model and year.

Leave a Reply

Your email address will not be published. Required fields are marked *